your position:Home > News > product news > IMAJE 9232 inkjet printer mixi.....
Contact us
CONTACT US ,BEST SERVICE AND COST IS FOR YOU    Tel:86-512-62810865      Fax:86-512-67301180       Email: sales@cheef.cn    Whatsapp &MP and wechat:+86 181 6857 5767Contact Now

News

IMAJE 9232 inkjet printer mixing cylinder installation

IMAJE 9232 inkjet printer mixing cylinder installation

Let's take a look at how to install the mixing cylinder of the 9232 machine

Let's install the solvent pump first,

Get it on first:

                   

The screws should be loosened a little, not so tight:

                   

Then we'll tighten it up:

                   

Then we put this fixed block downbe careful when placing

Pay attention to the lower wires when installing

Then install it like this:

                    

You can install the holders

These fixed bars are so installed:

Then we put the mixing cylinder on, this must be stuck in place, otherwise it will leak ink:

                    

Let's put the lid on

This O-ring must be put on:

Get a little wet:

           

Let's put the lid on:

With screws installed, the mixing cylinder is basically installed

                    

Be sure to tighten the screws.

Now put these two tubes on:

Then install the solenoid valve:

We installed the drive plate:

       

Put the lines in order, 12345:

And then we plug the lines in now:

If these lines we want to tear down, we must remember, they are all in order, 12345

The jack above doesn't have to be plugged in

Then one of the ones here was supposed to be connected to the cleaning pump:

Then this wire is connected to the condenser:

Be sure to remember.

Secure the pressure sensor, with a strap, be sure to secure it tightly:

After this is fixed, then we plug in the line of the pressure sensor

Just this hole, plug in here:

The mixing cylinder is already in place.

Special attention should be paid to the mixing cylinder washers and so on, check whether it is installed, whether it is crooked or deformed and so on

Be sure to see it

Otherwise when it comes to ink supply, it will leak air and ink:

And above, it's the same