How to see Videojet 2351 explainer video?

Now it is the Chinese interface, here are the print files, print frequency, current count, and switch language point settings:

click control:

Enter the language to switch:

There is a time and date display here, and the total number of prints is displayed.

There’s a start button here:

There are run and stop; the lower left corner is used to adjust the delay, the printing delay is adjusted inside, the maximum is 3,000, the minimum is 0,This delay can be adjusted here or by software:

Then click Settings:

to tool:

The activation state of the nozzle is displayed here. If there is a printing delay, 0 means no default; if there is a printing speed, it can be adjusted according to the on-site printing situation. Right and from right to left:

Here are the consumables:

When supplying ink for the first time, after inserting the ink cartridge into the ink tank, tighten it:

Then do this, and then select yes to prime the ink, about 5 minutes:

The following is the ink drain, it takes about 10 minutes to clean the ink:

This is a sensor inside:

Set up standard built-in sensors here:

The following one is to reset the sundry mat maintenance cycle:

This is the debris pad, which is equivalent to a filter screen, which is installed at about this position of the nozzle. It is a consumable item, and it is a cycle that can be reset after it is replaced:

Here is the control:

The first is the language just spoken, and the second is screen correction:

There will be a countdown after the calibration is complete:

The third changes the date and time; the fourth is the image control:

On the side is the import information:

Internal and external:

The inside is the information that has been imported. These 3 information have been imported and can be deleted:

Just if you want to import new information, you can use the software to complete the information on the computer, then insert the U disk into this position, and it will display the external:

Click on the outside and then click on the information name inside, click on import, the information will be imported here, only the software can be deleted in the machine, and the information changes must be operated on the computer:

Select a printhead:

There are input and output, there is an encoder in it, and the printed information can be seen in the print model, production direction, print quality, etc., and you can see it in it:

It needs to be plugged in to display the interior and exterior. If not, a warning will appear:

Here is the ink cartridge usage information:

Click filter lifetime: