How to assemble the viscometer of Domino A120 inkjet printer?
You can first attach this white connector to the glass tube:
Then put the glass tube into the viscometer's housing like this:
Then put the steel ball in.
Then install it:
Be sure to get stuck at both connectors:
Install them:
Then install the screw cap, tighten a little, do not use too much force, otherwise the bottom edge is easy to crack:
If it is the first time to dismantle, pay attention to, it itself is coated with a layer of glue, if you use a lot of force, it will crack:
Once the viscometer is assembled, plug it in like this: